Products

Product : Mistral 260

Desolder Station

With touch screen control display, makes the use of an additional CPU unnecessary!! USB printer or storage device can directly be connected to the control.

Forced air convection reflow oven

  • Forced air convection heat to maximum temperatures up to 300°C.
  • For lead free soldering
  • Forced air convection provides uniform heating and prevents shadowing.
  • Three heat zones, each independently controlled for accurate temperature profiles.
  • Bench-top unit can be converted to a stand-alone unit by use of the optional cabinet and also integrated into a fully conveyorized production line.
  • Output to printer, for print-out program data and temperature profiles.
  • Full colour touch screen for easy programming with user friendly interface.
  • Viewing panel allows visual inspection of reflow process.
  • Detachable thermocouple for measuring substrate temperatures.
  • The Mistral 260 convection reflow soldering systems uses re-circulated hot air to accomplish reflow at much lower temperatures than IR systems. Using constant, even heating, a great variety of board sizes will reach reflow temperature with the same heat profile. By eliminating set-up time your production line can work to its fullest capacity.

     

    Convection heating provides many other advantages over IR. In addition to the wide process window it works with

  • No shadowing
  • No belt load sensivity
  • No cold solder joints
  • No colour sensitivity
  • No hot spots
  • 3 zone temperature control
  • With a belt width of 265mm(over 10”) and consistent temperature across the entire width the Mistral can easily accommodate your entire production line speeds up to 0.6 meters/minute.

    User friendly touch screen with total control.
    The monochrome graphics system ensures swift operator training with simple menu driven commands. In most cases the operators are self-sufficient within minutes of their introduction to the system. The easy-to-use comprehensive program includes: 

    3 zone temperature control, Full process monitoring, Built-in profiling

     

    “Environment friendly” is more then just a catch to the Mistral designers. With reduced energy consumption and carefully controlled air-flow and exhaust systems, your plant will only benefit from its introduction. Ease of access to all parts of the machine ensures fast and easy maintenance. Managing information is quickly available and ancillary processes, such as glue curing, are easily programmed. The Mistral 260 reflow system is built to last and to perform to the highest standards throughout its long lifetime.

    Technical information

  • Power requirements: 208/240VAC 1-phase
  • Rated power max.: 3650 Watts
  • 3,8” monochrome touch screen.
  • Dynamic warming-up control ensuring stable temperatures
  • and virtually no overshoot.
  • USB port for direct printing or external storage.
  • Profiling software for temperature data recording.
  • Graphic display mode for viewing temperature on a time base.
  • 2 pre-heat and 1 reflow zone.
  • Stainless steel spring wires conveyor belt
  • Conveyor speed: 15 - 60 cm/min(6 – 23 inch/min)
  • Up to 300ºC for lead free soldering.
  • Clearance for assemblies up to 25mm(1 inch)
  • Soldering width: 265 mm(10 inch)
  • Length process chamber: 860 mm(43 inch)
  • Bottom cooling fans at offload section
  • Heat-up time: approx. 15 min.
  • Dimensions: 1540 x 570 x 340 mm(L x W x H)
  • Net weight: 60 kg
  •  

       
     
    Back to Top